Equipment Photos

Equipment Details

Inventory Number: 63209
Category: Cleaning Systems
Manufacturer: Baron Blakeslee

Baron Blakeslee MLR-120LE-DS/ATH-35 SPL Bi-solvent Vapor Degreaser System. Equipment designed for Kyzen DA3520 Bi-solvent and Novec 71IPA solvent. Configured with one DA3520 immersion pre-clean tank and one solvent degreaser tank.  

MLR-120LE Solvent Degreaser:
125 percent Freeboard. 4 side tank insulation. All solvent wetted parts of stainless steel T-304 or greater. Magnetic drive spray pump with foot switch operated spray lance will allow you to manually clean your oversized PCB assemblies. Magnetic drive recirculation pump and filtration system. 10 micron cartridge filter. Aluminum motorized roll up cover. 
Stainless steel T-304 water separator. Stainless steel cooling coils Hot Gas Bypass. VaporTrap™. Solvent vapor control (shuts off heat if primary refrigeration fails). High temperature control (prevents heater burnout). Digital liquid temperature control (controls solvent boiling temperature). Low Level Control (shuts off heat if solvent level falls to low). Vapor Up Control (prevents use of spray lance unless vapor zone is fully established). 

Working Dimensions:
Vapor Zone: 20 in. L x (L to R) x 12 in. W (front to back) x 10 in. H vapor zone.
Rinse Sump: 10 in. L x (L to R) x 12 in. W (front to back) x 10 in. H liquid level.

Baron Blakeslee Model ATH-35 SPL: 
Automatic Transporter/Hoist: This Hoist is a cantilevered type, two (2) dimensional material handling system. The transporter system consists of a cantilevered winch package system and support structure. It also includes control box and remote emergency stop button.

A2 DA3520 Immersion Pre-Clean Tank: 
Working Dimensions: 21 in. L (L to R) x 12 in. W 
(front to back) x 10 in. immersion.
Freeboard: 5 in. H.
Heat Input: 1.5kW.
Power Supply: 240VAC, 1 Ph, 60 Hz.
Total Operational Solvent Fill: 14 Gallons.

NEW Never Installed, was $75,000 New

Now (USD): $25,000.00

Products Similar to: Baron Blakeslee MLR-120LE-DS/ATH-35 SPL

Used EDC 100

Inventory Number: 51023
Now (USD): $2,500.00

EDC 100 Exclusive Design Co. Rigid Disk Cleaning System. Uses brushes and surfactant to scrub disks. LCD display. Analog control of scrub/rinse speed and spin dry speed. 115V, 60 Hz.

Product Details

Used Layton Technologies IMMASYS FS2012

Inventory Number: 63094
Now (USD): $6,500.00

Layton Technologies IMMASYS FS2012 IPA Cleaning System. PLC control for process flexibility and ease of use. Stainless steel construction. Bath Area: 27 in. L x 17 in. W x 12 in. D. 208/120V, 3 Ph, 50/60 Hz. Pulled from working environment but we are unable to test. Cooling coil compressor included with unit but will need to add refrigerant. Sold As Is.

Product Details

Used Branson B452R

Inventory Number: 63955
Now (USD): $21,000.00

Branson B452R Ultrasonic Vapor Degreaser Cleaning System. Includes optional automated hoist system. Designed to comply with EPA environmental regulations on solvent emissions, an important environmental and economic consideration. Some of these features also facilitate OSHA compliance. The units include, as standard, a number of engineered improvements designed specifically to minimize solvent losses. The following list details some of these more important features: Freeboard ratio of 100% to minimize diffusion losses due to drafts Sub-zero freeboard condenser to provide a cold barrier minimizing emissions Primary refrigerated condensing coil to efficiently condense the bulk of the solvent vapors prior to reaching the sub-zero condenser Internal water separator keeps all solvent within the unit at all times Recirculating pump and filter to remove particulate and extend solvent life. Vapor zone 28.7" x 15" x 8.5"D. Working area 10" x 12" x 8"D. 208 V, 3 PH, 60 Hz, 40A

Product Details

Used Ultron UH117

Inventory Number: 64026
Now (USD): $7,500.00

Ultron UH117 Wafer Cleaning System. Ultron Systems' Model UH117 Wafer Cleaning System provides an ideal solution for cleaning wafers after sawing or scribing. Operation is semiautomatic and fully programmable via the new touchscreen LCD panel. Microprocessor control ensures precise, flexible, uniform, and repeatable cleaning. Up to 10 programs can be stored for different processes. Each program may have up to 99 different cleaning/rinsing/drying steps with a maximum of 999 seconds per step. The unit is capable of cleaning wafers up to 8-inches in diameter or up to 6-inches in diameter mounted on a film frame or grip ring. An optional liquid additive injection feature is available to facilitate the cleaning cycles. Both hot and cool dry modes are available for faster, more efficient drying.

FEATURES:
- Semiautomatic operation, fully programmable
- Touchscreen LCD panel
- Microprocessor control, ensures precise, flexible, uniform, and repeatable cleaning
- Store 10 programs, each with up to 99 different clean/rinse/dry steps, with 999 seconds maximum per step
- Non-volatile memory for program storage
- Accommodates up to 8" diameter wafers; and up to 6" diameter wafers mounted on a film frame or grip ring
- Interchangeable chuck capability

Currently has 5” dia. chuck. 115V, 50/60 Hz, 5A

Product Details